Safety Measures - Vitek VT-1641 W Die Betriebsanweisung

ENGLISH
CHOPPER VT-1641
Description
1. On/Off button with rotation speed indicator
2. Rotation speed regulator
3. Motor module
4. Lid of the bowl
5. Sealing ring
6. Chopper-knife
7. Bowl
8. Axle of the bowl
9. Mat to protect from sliding

SAFETY MEASURES

Before using the unit, read these instructions carefully and keep them for future reference.
• Before connecting of the unit to the power supply network make sure that the voltage pointed out
on the unit corresponds with the voltage of the power supply network.
• The chopper features efficient and fast operation, but operation time of the unit should not exceed
30 seconds. Intervals between the operation cycles should be at least 2 minutes long.
• Do not use the unit outdoors.
• Use only the attachments supplied with the unit.
• Use this device only for the purpose intended, as it is described in the manual.
• Before starting using the device, make sure than all parts are correctly installed.
• Use the unit on the flat stable surface.
• The products to be processed are placed into the chopper's bowl before the unit is switched on.
• Do not overload the bowl with products.
• The blades of the chopper-knife are very sharp and present a danger. Handle the knife with cau-
tion.
• In case the knife's rotation is hindered unplug the unit and carefully remove the products hindering
the knife's rotation.
• Remove the products and drain the liquid from the bowl only after the knife has completely
stopped rotating.
• Never leave the operating unit unattended.
• Unplug the unit before cleaning or when you do not use it.
• Do not use the unit near hot surfaces (such as gas or electric stoves or ovens or heaters).
• Provide that the power cord is not hanging over the edge of the ironing board and make sure that
it does not touch hot surfaces.
• Do not pull or twist the power cord.
• Do not touch the cable plug with wet hands.
• Do not use the unit, if its power cord is damaged.
• Do not try to repair the unit yourself. If there are any damages in the unit apply to the authorized
service center.
• In order to avoid electric shock do not immerse the device into water or other liquids. If the unit
falls into water,
− do not touch the water,
− unplug it immediately. And only then you can take it out of the water.
− apply to the authorized service center for chopper repairs.
• Never allow children to use the unit as a toy.
• Close supervision is necessary when any appliance is used near children or disabled persons.
VT-1641.indd 3
ENGLISH
3 3
29.11.2011 12:53:34