Master R02 X-bike Benutzeranleitung Seite 30

Instruction of computer
Functions and Operations
Batteries Installation
Please install one piece of AAA 1.5V batteries in the battery case on the back of monitor.
(Whenever the battery is removed, all the functions values will be reset to zero.)
Auto On/Off
While the user starts to do exercise, the Display will show out the workout value automatically. Once
stop exercising over 256 sec, the Display will turn off. But the workout value will be hold. While user
starts exercise again, workout value will accumulate continuously.
Auto Scan
After the monitor is power on or press Mode key, the LCD will display all functions values from
Time-Calories- Speed- Distance-Odometer. Each value will be held for 6 seconds.
Speed
Display the current training speed from 0.0 to 999.9 KPH or MPH. User also can press Mode key to
display the Speed value.
Distance
Display the trip distance from 0.0 to 999.9 Km or Mile. User also can press Mode key to display the
distance value.
Time
Display the workout time from 00:00 to 99:59. User also can press Mode key to display the workout
time value.
Calories
Display the calories consumption during training from 0.0 to 9999. User also can press mode key to
display the calories consumption value.
Odometer
Display the total accumulated distance from 0.0 to 9999. User also can press mode key to display the
Odometer value.
Reset
Press Mode key for 2 seconds, all the function value except Odometer will be reset to zero.
Note:
1. If the computer displays abnormally, please re-install the battery and try again.
2. Battery Spec: 1.5V UM-4 or AAA (1PCS).
3. The batteries must be removed from the appliance before it is scrapped and that they are disposed of
safety.
EN