Introduction; Identification - Markings; Intended Use Of The Refrigerated Cabinet; Technical Description - AFINOX AGX Bedienungs-, Installations- Und Wartungsanweisung

1.

INTRODUCTION

This instructions manual refers to the AFINOX REFRIGERATED CABINET type:
• AGX
The contents of the manual are intended to provide information on:
• use of the refrigerated cabinets;
• technical features;
• handling, installation and assembly instructions;
• information about training staff on the use of the cabinet;
• maintenance operations.
The manual must be considered as an integral part of the cabinet and, as such, must be kept for future reference throughout
the life of the cabinet.
The manufacturer can accept no liability for the following situations:
• improper use of the cabinet;
• improper installation, performed without complying with the procedures described in this manual;
• a defective power supply;
• severe failings in the scheduled maintenance operations;
• unauthorized alterations or other actions;
• use of non-original spare parts, or of parts unsuited to the model concerned;
• partial or total failure to comply with the instructions.
• holes made on the inside of the cabinet.
All electrical apparatus can be hazardous to health. Current standards and legal requirements must be complied with
during the installation and use of any such equipment.
2.

IDENTIFICATION - MARKINGS

Figure 1 – Exemple of the nameplate attached to the cabinets
3.

INTENDED USE OF THE REFRIGERATED CABINET

This refrigerated cabinet is intended for preserving tubs of ice cream and has an incorporated refrigerating unit.
The working temperature of the refrigerated cabinets is between -18°C ÷ -24°C at an ambient temperature of 25°C and 60°
HR.
Remember that the BT units are not designed to operate as freezers but as low temperature storage units and there-
fore only food at a temperature below -18°C must be placed inside. According to the EEC directive 93/43 concerning
HACCP the temperature of the food must be brought to the above negative value only via the use of deep freezing
units.
4.

TECHNICAL DESCRIPTION

In the model described in this manual, the AFINOX cabinet is refrigerated by means of a forced air flow. All the materials
used in the manufacture of these units are guaranteed to be suitable for use with foodstuffs. The gases used in the refrigerat-
ing circuit are in compliance with current legal requirements.
Operation
The gas in the refrigerating circuit is first compressed and liquefied, then allowed to evaporate in the evaporator, which is
situated inside the refrigerated cabinet. This cycle leads to the absorption of heat from inside the cabinet, which is itself
cooled as a result. The heat produced is then dissipated to the outside environment by means of the condenser, which is
situated on the outside of the refrigerated cabinet.
Operation of the cabinet is governed by parameters that are set on the control panel.
For correct use of this manual, identify the model
via the specifications on the identification plate.
The unit is identified by the following parameters:
1. model
2. code
3. serial no.
4. job order
5. order
6. year of manufacture
7. noise
.
10