Switch The Device On And Off; Transport; Storage; Care And Service - Kärcher LBL 2 Battery Originalbetriebsanleitung

Switch the device on and off

Use the power switch to switch the device on and off.
1. Slide the power switch forwards to position "1" or "2"
(LBL 4 battery only).
The device starts up.
2. Slide the power switch backwards.
The device stops.

Transport

CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during transporta-
tion.

Storage

CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during storage.
Note
Always store the device in a dry place and remove the
battery pack.

Care and service

The device is maintenance-free.

Troubleshooting guide

Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
As the battery pack ages, even if it is looked after, its ca-
pacity reduces such that the full run time will no longer
be reached when fully charged. This does not indicate a
defect.
Type plate
The major device information is specified on the type
plate.
The location of the type plate on the device is specified
in the "Device description" chapter.
Faults on the device
The device does not start up
The battery pack is not inserted correctly.
1. Push the battery pack into the mounting in the de-
vice until it audibly latches into place.
The battery pack is discharged.
1. Charge the battery pack.
The battery pack is in sleep mode.
1. Press and hold the power switch longer or press the
power switch a second time.
The battery pack is defective.
1. Replace the battery pack.
The device stops during operation
The battery has overheated
 Stop working and allow the battery to cool down to
the permissible temperature range. This can take a
few minutes.

Warranty

The warranty conditions issued by our relevant sales
company apply in all countries. We shall remedy possi-
ble malfunctions on your appliance within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)

Technical data

Device performance data
Maximum air
speed
Maximum volume
flow rate
Working voltage of
the battery
Speed control
Speed levels
Battery pack in-
cluded
Battery charger
type
Dimensions and weights
Weight
Length x width x
height
Determined values in acc. with EN 60335-2-
79 * Measurements were made with the flat nozzle
Hand-arm vibration
value
Uncertainty K
* Sound level
* Uncertainty K
pA
* Sound power lev-
el L +
WA
* Uncertainty K
WA
Subject to technical modifications.

EC Declaration of conformity

We hereby declare that the machine described below
complies with the relevant basic safety and health re-
quirements in the EU Directives, both in its basic design
and construction as well as in the version placed in cir-
culation by us. This declaration is invalidated by any
changes made to the machine that are not approved by
us.
English
km/h 210 210 250
3
m /h 220 220 330
V 18 18 36
- - Yes
- - 2
- Bat- -
tery
Pow-
er 18/
25
- Bat- -
tery
Pow-
er
18V
Stand
ard
Char
ger
kg 2 2,5 2,2
mm 975 x 975 x 975 x
170 x 170 x 170 x
305 305 305
2
m/s 1,7 1,7 2,1
2
m/s 0,2 0,2 0,2
dB(A) 74 74 82
dB(A) 2 2 2
dB(A) 88 88 96
250
330
36
Yes
2
Bat-
tery
Pow-
er 36/
25
Bat-
tery
Pow-
er
36V
Quick
Char
ger
3
975 x
170 x
305
2,1
0,2
82
2
96
11