Appendix - Husqvarna 2011 CR 125 Merkmale, Gebrauch, Wartung

APPENDIX

AFTER-RACE CHECK POINTS
After racing, first clean the motorcycle and then inspect the
entire motorcycle, with special attention to the items listed in
«MAINTENANCE» table (Appendix A), such as the air cleaner,
carburetor, brakes, etc.
Carry out general lubrication, and make adjustment as neces-
sary.
After every race, always check the correct tightening of all
screws and bolts.
STORAGE
When the motorcycle is to be stored for any length of time, is
should be prepared for storage as follows:
- Clean the entire motorcycle thoroughly.
- Empty the fuel from the fuel tank, and empty the carburetor
float bowl. (If left in for a long time, the fuel will deteriorate).
WARNING
Never litter the environment with fuel, and
let the engine running in open air, never in
closed rooms.
- Lubricate the drive chain and all the cables.
- Spray oil on all unpainted metal surfaces to prevent rusting.
Avoid getting oil on rubber parts or in the brakes.
- Set the motorcycle on a box or stand so that both wheels are
raised off the ground. (If this cannot be done, put boards un-
der the front and rear wheels to keep dampness away from
the tire rubber).
- Tie a plastic bag over the exhaust pipe to prevent moisture
from entering.
- Put a cover over the motorcycle to keep dust and dirt from
collecting on it.
To put the motorcycle back into the use after storage.
- Make sure the spark plug is tight.
- Fill the fuel tank.
- Run the engine for about 5 minutes to warm the oil then drain
the oil.
- Put in fresh transmission oil (page 19).
- Check all the points listed under the inspection and Adjustment
Section (Appendix A).
- Lubricate the points (listed in the Lubrication Section (Appendix
A).
47