Riding - Husqvarna 2011 CR 125 Merkmale, Gebrauch, Wartung

RIDING

BEFORE EVERY RIDE MAKE FOLLOWING CHECKS
WARNING!
Before each ride, to prevent accidents or failures during ride,
make sure to go through following list.
1. Check all fluids
A. Transmission oil level
B. fuel level
C. coolant level
Make sure all caps are properly adjusted.
WARNING*: Don't remove radiator cap when
hot!
2. Check all controls
A. Throttle handgrip
B. Clutch lever
Make sure cables are not damaged and turn smoothly.
3. Check brakes
Look for brake fluid leaks and worn hoses. Check for proper
functioning.
4. Check suspensions
Compress fork and rear suspensions. Look for oil leaks and
ensure proper functioning.
5. Check wheels
Check spokes and look for worn bearings.
Check rims and tyres.
Check tyre pressure.
6. Check chain rollers and sprockets
Check wear on chain rollers and sprockets
Ensure chain is correctly adjusted and lubricated.
7. Check air filter and intake system
Check that air filter is clean
Check all rubber connections and clamps.
16
8. Check exhaust system
Check hook up, look for cracks
Check muffler.
9. Check torque
A. Spark plug (see page 23).
B. General check of torque
10. Check steering action
Check bearing play.
11. Check the electric system (WR).
Start the engine and check that the front and rear lamps, the
stop light, the turn signals the cluster warning lights and the
horn are working correctly.
WARNING*: Failure to perform these checks
every day before you ride may result in se-
rous damage or a severe accident.
RUNNING IN
To obtain the best settling of the engine moving elements, for
driving your motorcycle to the best of your capability, run in the
engine for several hours, following these procedures:
1. FROM STOP POSITION. Start the engine and run at idle, but
open the throttle periodically and briefly until the engine is tho-
roughly warmed up. Within 3-4 minutes the coolant temperature
will have reached approximately 60° C/140° F. (Do not ride
the motorcycle).
2. Stop the engine, and let it cool down naturally until its tem-
perature is equal to the ambient air temperature. This will allow
the piston to align itself to any imperfections which might exist
at the cylinder wall.
3. Repeat steps 1 and 2. (Do not ride the motorcycle).
4. Bring the engine up to normal running temperature. Ride the
motorcycle approximately 10 minutes at moderate speeds. Then
repeat cool down procedure.AVOID HARD ACCELERATIONS.
5. Bring engine up to normal temperature. Ride motorcycle
approximately 15 minutes at moderate to high speeds. Again
avoid hard accelerations.
6.Repeat cool down procedure.
7. Full throttle operation must be avoided until the engine has
reached operating temperature, even after the break in process
is completed. When the above procedure is followed correctly,
engine durability and performance will be greatly enhanced.
CHECKS WHILE RUNNING IN
When running in, the following should be checked out:
- WHEELS SPOKES TENSION;
- TIGHTENING OF WHEELS;
- FORK PIN TIGHTENING;
- CHAIN ADJUSTMENT;
- STEERING BEARING PLAY;
- HANDLEBAR TIGHTENING;
- ENGINE GRIP TO FRAME;
- SUCTION FITTING GRIP;
- HEAD AND CYLINDER NUTS GRIP.
Note*:
After break in, install a new spark plug and
change the transmission oil.
After running-in, check that vehicle nuts and
bolts are properly tightened.