HomeMatic HMW-LC-Sw2-DR Bedienungsanleitung Seite 55

channel LED flashes slowly (after approx.
3 seconds). The module is now in teach-in mode.
• Now, actuate a button on the button input (on the
same module or any other module on the bus) that
you want to assign to the actuator (channel).
• The actuator (channel) is now assigned with this
switch input and the channel LED goes dark on the
actuator.
• Test the assignment by pressing the respective
button. The actuator (channel) should react
according to the configuration of the button input.
• If you want to assign another button input to the
actuator (channel), repeat this procedure.
Depending on the actuator, button inputs are taught-in
differently:
Actuator
Switch actua-
tor, Dimming
actuator
Button behavior
Taught-in buttons behave like
toggle switches
55