Teaching-In; Teaching Button Inputs To Actuator Channels - HomeMatic HMW-LC-Sw2-DR Bedienungsanleitung

6.1 Teaching-in

Please read this entire section before starting
the teach-in procedure.
To integrate the actuator into your Homematic system
and enable it to communicate with other Homematic
devices, you must teach it in first. You can teach-in the
device directly to other Homematic devices or to the
Homematic Central Control Unit:

6.1.1 Teaching button inputs to actuator channels

If you would like to teach-in the actuator to one or
more Homematic devices, you must put the devices to
be taught-in into teach-in mode and select the required
teach-in channel. To do this, proceed as follows:
The button inputs are not assigned to any actu-
ator channels in factory status (not the actuator
channels of the device on which they are loca-
ted either)
Assignment of button inputs to actuator channels
• Press the programming button of the actuator
(channel) to be assigned on the module until the
54