Maintenance - Chicco TRIOLOVE Bedienungsanleitung

Before carrying or lifting the carry
cot, the base shall be adjusted in
the lowest position.
cot should never be lower than the
body of the child.
moved/hidden/covered when the
product is used outside car for
unattended sleeping.
CLEANING AND MAINTENANCE
This product requires periodical maintenance. Cleaning and
an adult.
CLEANING
Clean the fabric parts using a wet sponge and neutral soap.
Periodically wipe clean plastic parts with a soft damp cloth.
Always dry the metal parts to prevent the formation of rust
if the stroller has come into contact with water.
WASHING
are removable and washable; in order to remove them,
please refer to the paragraph REMOVING THE CARRY COT
LINING.
it is advised to carefully follow the washing instructions
shown on the item's label.
Below are the cleaning symbols and their meanings:
Wash by hand in cold water
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean

MAINTENANCE

Always let the metal parts dry to prevent the formation
of rust. Do not submerge the carry cot in water. Routinely
wipe clean plastic parts with a soft damp cloth. To avoid
stroller are free from dust or sand. Do not leave the product
may discolour. Lubricate the moving parts only if necessary,
with a light application of a silicone based lubricant.
CARRY COT FEATURES
The carrycot is comprehensive of the following compo-
tation.
1. The carry cot is supplied with the fabric lining already fit-
HOOD
The carry cot is equipped with a sun canopy and wind-
shield that can be adjusted to various positions.
ATTACH AND REMOVE
2. To mount the hood on the carry cot, position the pin
joints found on both sides of the carry out vertically (fig.
-
2A), and insert the two plastic ends in the slots as illus-
trated in fig. 2B.
3. To complete the mounting of the fabric part of the hood,
carry cot (fig. 3).
4. Then pass the metal pin through the fabric slot located
REAR OPENING
5. To ensure proper ventilation, the carry cot features a rear
opening; to open it, just fold the flap on the upper part of
the carry cot (fig. 5).
VISOR
6. The internal part of the visor features a fabric ring that al-
lows you to hang soft toys (fig. 6).
tion of your child (fig. 7).
COVER
8. Fasten the cover in place using the two side snap-but-
tons (fig. 8A) and insert the eyelet over the relative pin
located near the baby's feet (fig. 8B). To guarantee top
protection for your child, fasten the snap-buttons inside
the cover as shown in fig. 8C.
COMFORT KIT
The Comfort Kit features 2 shoulder pads and crotch strap.
ADJUSTABLE BACKREST - COMFORT SYSTEM
outer part of the carry cot near the baby's feet (fig. 10).
CARRYING HANDLE
11. The carrycot features a comfortable carry handle that
can be adjusted in three positions (fig. 11):
A) Transport
B) Middle
C) Rest
12. To put the handle in the vertical position, grasp it in the
buttons at the base of the handle at the same time and
then turn it downwards (fig. 12B – 12C).
WARNING: Do not transport the carrycot with the handle
-
in middle or rest position, but only with the handle in carry-
ing position (vertical).
14
-