Chicco TRIOLOVE Bedienungsanleitung Seite 16

FASTENING AND REMOVING THE CARRY COT IN THE
CAR
To install the CAR KIT, following the assembly instructions
below before positioning the carry cot in the car:
BUCKLES FOR CAR SEAT BELTS
24. WARNING!
(diag. 24).
The carry cot is now ready to be positioned in the car.
FASTENING THE CARRY COT IN THE CAR
25. To fasten the carry cot to the rear seat, position it at the
centre, aligned with the car seat, and fasten it using the
seat belts of the two outer seats (fig. 25).
26. If the rear seat of your car has a 3-point seat belt in the
middle seat too, the carry cot can be fastened also shift-
ed to one side occupying the middle seat and lateral
seat using the seat belts of these two seats (fig. 26).
(fig. 27).
WARNING! Never use the carry cot in the car with the
Follow the steps below on both sides:
le (fig. 30A – 30B) and rotate the red bar to its initial posi-
tion so that it fits inside the loop (fig. 30C).
31. Pull the seat belt toward the retractor pressing the carry
cot against the seat so that it is fastened well (fig. 31).
WARNING!
32. WARNING!
32).
REMOVING THE CARRY COT FROM THE CAR SEAT
Follow the steps below on both sides.
le's red tab outward and pushing (fig. 33) to release the
to the seat belt. WARNING! Never use the seat belt to
it can be dangerous!
the belt (fig. 34A) and rotate the red bar so that it comes
out (fig. 34B).
FASTENING THE CARRY COT TO THE STROLLER
Prepare the stroller to mount the carry out according to the
stroller's instructions.
WARNING: Before using the carry out on the stroller, the
safety harness must be fit under the mattress in the rel-
evant space (fig. 16A – 16B).
WARNING: To fasten the carry cot to the stroller structure,
remove the seat first.
35. Hold the handle in carrying position (vertical) and po-
sition the carry cot in the vertical joints until you hear
the baby's feet end facing the stroller's handle (fig. 35A).
To facilitate fastening the carry cot on the stroller, there
are labels with instructions on both sides of the fabric
showing you the correct alignment of the carry cot with
the fasteners (fig. 35 B). WARNING:
on it upwards.
REMOVING THE CARRY COT FROM THE STROLLER
Place the handle in carrying position (vertical)
36. Pull the button on the front of the carry cot (fig. 36A)
from the stroller structure by pulling it up (fig. 36B).
WARNING: The fastening and releasing operations can be
carried out also with your child inside the carry cot; how-
with the child's weight. Pay attention when carrying out
the above mentioned operations.
Important Note: the images and instructions in this man-
ual refer to a single carry cot version. Some of the compo-
nents and functions described here may vary according to
the model purchased.
-
-
16