Transporting The Patient On Flat Surfaces - Stryker Stair-PRO 6250 Bedienungs- Und Wartungshandbuch

TRANSPORTING THE PATIENT ON FLAT SURFACES

Figure 19 - Transporting the Patient on a Model 6250
CAUTION
Casters are not suitable for all surfaces. Caution should be used at all times.
Model 6250
To roll the Model 6250 Stair-PRO
backrest tube to tip the chair back. Once the chair is tipped back, use either the head end lift handles or the backrest
tube to roll and guide the chair. Lift the chair over and around obstructions with the head end and foot end lift handles.
Model 6251
To roll the Model 6251 Stair-PRO
the head end lift handles or the backrest tube. Lift the chair over and around obstructions with the head end and foot
end lift handles.
Model 6252
To roll the Model 6252 Stair-PRO
to the head end lift handles, the extendable upper control handle can be used in any position to roll and guide the chair.
Extend the upper control handle by pulling the red release cable with one hand, and pulling up on the control handle
with the other. Release the cable to lock the handle in either the intermediate or fully extended position. Lift the chair
over and around obstructions with the head end and foot end lift handles.
WARNING
Do not push the Model 6252 with the upper control handle in the fully extended position. Pushing the chair with the
handle in the fully extended position may cause the chair to tip when obstacles are encountered.
www.stryker.com
Operation Guide
® over flat surfaces, use either the locking rear lift handles (if equipped), or the
® over flat surfaces, push and guide the chair from the rear of the patient, using either
® over flat surfaces, follow the same method as above for the Model 6251. In addition
6250-001-161 REV D
Figure 20 - Transporting the Patient on a Model 6252
Return To Table of Contents
1-19
English