Using The Patient Transfer System - Stryker Stretcher Chair Betriebsanleitung

USING THE PATIENT TRANSFER SYSTEM

C
B
A
WARNING
When using the patient transfer system, always lock the brakes on all stretchers or beds being used and
always be sure the transfer surface is securely on the surface of the mating stretcher or bed. The Stretcher
Chair patient surface and the surface of the mating stretcher or bed must be at the same height before the
patient is transferred. Failure to follow these guidelines may result in an unstable surface and patient injury.
Be sure the Stretcher Chair is as close to the mating surface as possible and at the same height or slightly
higher (not to exceed 1").
Pull the release knob (A) and lower the siderail down onto the mating stretcher or bed. The siderail arm rest
(B) should be flat to serve as a lead to the transfer surface. If it is not, push the arm rest toward the foot end
of the stretcher to release the arm rest latch (C), then rotate the arm rest up so it is parallel with the siderail.
CAUTION
Be sure the brakes on both the Stretcher Chair and the mating bed or stretcher have been applied before
proceeding with the patient transfer.
Using a sheet, draw the patient onto the mating bed or stretcher.
Operation Guide
1−6