Ingersoll-Rand 500PS3–EU Bedienungs- Und Wartungshandbuch Seite 2

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this
tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
TORQUE ADJUSTMENT
To adjust the torque on these Twin Blade Impulse Wrenches,
proceed as follows:
1. Remove the Adjustment Hole Plug.
2. Rotate the Drive Shaft until the Torque Adjustment Screw
is visible in the opening. There is no colored paint in the
head of the Torque Adjustment Screw.
3. Using either a 2 mm or a 1.5 mm hex wrench, rotate the
Adjustment Screw clockwise to increase the torque
output and counterclockwise to decrease the torque
output. Do not rotate the Oil Plug.
Make all final adjustments at the job.
4. Replace the Adjustment Hole Plug.
CHANGING THE MECHANISM FLUID
To change the Mechanism Fluid in the Impulse Mechanism,
proceed as follows:
1. Using a hex wrench, remove the three Hammer Case Cap
Screws and Lock Washers. Lift the Hammer Case off the
Motor Housing over the Drive Shaft. Remove the
Hammer Case Gasket.
WARNING LABEL IDENTIFICATION
Always wear hearing
protection when operating
this tool.
Do not carry the tool by
the hose.
90 psig
Operate at 90 psig (6.2 bar/
(6.2bar/620 kPa)
620 kPa) Maximum air pressure.
ADJUSTMENTS
WARNING
WARNING
WARNING
2. Lift the assembled mechanism off the Rotor.
3. Using a 2.5 mm hex wrench, unscrew and remove the Oil
Plug. Remove the Oil Plug Seal and Oil Plug Seal
Support.
4. Using either the 1.5 mm or the 2 mm hex wrench
furnished with the tool, rotate the Adjustment Screw
without paint in the wrench hole, counterclockwise until
it stops.
5. With the oil plug opening downward over a container,
rotate the Drive Shaft to purge the fluid from the
mechanism.
6. Using the syringe and fluid from the Fluid Replacement
Kit (Part No. EQ106S–K400), fill the mechanism with
the fluid furnished in the Kit until the fluid overflows the
fill hole. Model 500PS3–EU will require 9 cc of fluid;
Model 700PS3–EU, 12 cc and Model 900PS4–EU, 17 cc.
(Refer to Dwg. TPD1265.)
DO NOT SUBSTITUTE ANY OTHER FLUID.
Failure to use the impulse mechanism fluid
provided could damage the tool, increase
maintenance and decrease performance. Use only
clean fluid in these tools.
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________