Using The Hair Clipper - Vitek VT-2568 BK Betriebsanweisung

ENGLISH
socket (1) on the lower part of the unit
body, connect the power adapter (9) into
the mains socket, switch on the unit set-
ting the power switch (3) to the "ON" posi-
tion, the on indicator (2) will light up red.
Lubricating the blade block
Before using the unit for the first time
remove the blade block (5) and lubricate it
with oil (10) (supplied with the unit).
–
To remove the blade block place the
clipper with the blades up and press on
the upper edge of the blade block with
your thumb to release it from the lock-
ing frame, as shown on pic. 1.
–
Points for applying the lubricating oil
are marked with arrows on the pic. 2.
Apply 1 drop of oil to each point.
–
To install the blade block back to its
place first insert its lower part to the
installation place and then carefully
press on the upper edge of the blades
until clicking to lock it, see the pic. 3.
–
Let the hair clipper operate for approxi-
mately 30 seconds to spread the oil
across the rubbing surfaces. After that
remove the surplus oil with a dry cloth
or a paper towel.
Notes:
–
Lubricate the blades after every use of
the hair clipper.
–
Use only the oil (10) supplied with the set.
–
Do not use vegetable oil or oil that
includes solvents. Solvents will evapo-
rate, leaving thick grease that may slow
down the blades motion.
Universal attachments (6) and (7)
Each universal attachment (6) and (7) has
5 positions for hair of different length,
which are marked on the scale on the left
side of the attachment:
–
M VT-2568.indd 6
universal attachment (6): 3 mm, 6
mm, 9 mm, 12 mm, 15 mm, see
pic. 4;
–
universal attachment (7): 18 mm,
21 mm, 24 mm, 27 mm, 30 mm, see
pic. 5.
–
The scale is situated on the left side
of each attachment, so the selected
hair length (mm) is shown opposite the
symbol « » on the left side of the
hair clipper.
–
Before installing, removing or changing
the universal attachments, switch the
unit off by setting the switch (3) to the
position «OFF»; if the unit is powered by
the power adapter, unplug it.
–
To install the universal attachment
insert its guides into the correspond-
ing grooves in the hair clipper body
and press the lock (8) to move it to the
selected cutting length according to the
scale, see pic. 6.
–
To remove the universal attachment (6)
or (7) press the lock (8) and pull the
attachment upwards.
Hair thinning function
The unit has the hair thinning function
which allows to visually improve the hair-
style by thinning out hair. Hair thinning
makes the hairstyle lighter and accentu-
ates the hair texture. Due to thinning out
the haircut keeps its style for a long time.
Hair thinning means cutting off separate
locks. It allows achieving smooth transi-
tion between locks of different length. Hair
thinning is performed at the final phase of
hair cutting.
To extend the hair thinning comb, move
the lock (4) to the utmost left position.
To remove the hair thinning comb, move
the lock (4) to the utmost right position
(see pic. 7, 8).

USING THE HAIR CLIPPER

–
For cordless use of the unit, charge the
battery fully following the recommenda-
tions above.
6 6
05.08.2016 17:02:41