Safety Measures; Using The Hair Clipper - Vitek VT-2512 R Betriebsanweisung

HAIR CLIPPER SET
Description
1. Attachments release button
2. Body
3. Power switch «0/I»
4. Charging indicator
5. Adapter cord slot
6. Base for attachment storage
7. Cleaning brush
8. Comb
9. Lubricating oil
10. Adapter
Attachments
11. Wide trimmer 40 mm
12. Telescopic attachment for 40 mm trimmer
13. Wide trimmer 30 mm
14. Telescopic attachment for 30 mm trimmer
15. Detail trimmer for removing short hair
16. Trimmer for cutting hair in the ears and nose.
17. Shaving attachment
18. Outer shaving block release buttons
19. Face and body trimmer
20. Attachment comb for trimmer (19)

SAFETY MEASURES

Before using the electric unit, read this instruction
carefully and keep it for further reference. Use the unit
according to its intended purpose only, as it is stated in
this user manual.
Mishandling the unit can lead to its breakage and cause
harm to the user or damage to his/her property.
•
Before connecting the unit to the mains for the first
battery charging, make sure that your home mains
voltage corresponds to adapter operating voltage.
•
Use only the attachments and the adapter supplied
with the unit.
•
Do not use the unit in places with high temperature
and relative humidity more than 80%.
•
Charge the battery at the temperature from +5°C
to +35°C.
•
Never use the unit if the attachments or the blades
are damaged.
•
Always keep the trimmer blades clean and lubri-
cated.
•
After each using clean the attachments with the
brush supplied to remove the cut-off hair.
•
Never leave the operating unit unattended. Hair clip-
per must be switched off during breaks in operation
or when you are not using it.
•
The adapter cord should not:
–
touch hot objects and surfaces,
–
be immersed into water,
–
run over sharp edges,
–
be used as a handle for carrying the unit.
•
The outer shaving net of the shaving attachment is
very thin, to avoid damaging the shaving net do not
apply excessive effort while shaving or cleaning.
•
To avoid injuries do not use the shaver with dam-
aged outer shaving net or inner cutting block.
•
Be careful when using the trimmer for cutting hair
in the ears and nose. Insert only the metal tip of the
trimmer attachment into the auricle or the nostril.
•
Do not allow children to use the units as a toy.
•
This unit is not intended for usage by children or
disabled persons unless they are given all the nec-
essary and understandable instructions by a person
who is responsible for their safety on safety mea-
sures and information about danger that can be
caused by improper usage of the unit.
•
For children safety reasons do not leave polyethyl-
ene bags, used as a packaging, unattended.
•
Attention! Do not allow children to play with poly-
ethylene bags or packaging film. Danger of suf-
focation!
•
Never use the unit if the adapter is damaged, if the
unit works improperly or after it was dropped. Con-
tact an authorized service center for all repair is-
sues.
•
Keep the unit out of reach of children.
THE UNIT IS INTENDED FOR HOUSEHOLD USAGE ONLY

USING THE HAIR CLIPPER

After unit transportation or storage at low tempera-
ture it is necessary to keep it for at least two hours
at room temperature before switching on.
Battery charging
The fully-charged battery provides about 45 minutes of
continuous unit operation.
–
Insert the connector of adapter (10) into the slot
(5) on the hair clipper body (2), insert the adapter
into the mains socket, the charging indicator (4) will
light up red.
–
Before the first use charge the battery during 3-4
hours. The following charging cycles will take about
1,5 hour.
–
The green color of the indicator (4) shows that the
battery is fully charged. After charging the unit, un-
plug the adapter (10) and remove the connector of
the adapter cord from the slot (5).
Notes:
–
Recharge the battery only after its complete dis-
charge.
–
Charge the battery at the temperature from +5° C
to +35° C.
–
Never leave the unit connected to the mains unat-
tended.
–
After a long period of non-use (more than 2
months), charge the battery completely (during 3-4
hours) before using the hair clipper.
Attachments
–
Keep the attachments on the base (6).
–
Before installing and changing the attachment
switch the unit off by setting the switch (3) to the
position «0»; if the unit is powered by the adapter,
unplug it.
3
ENGLISH