Using The Hair Clipper - Vitek VT-2542 GY Die Betriebsanweisung

USING THE HAIR CLIPPER

After unit transportation or storage at low
temperature it is necessary to keep it for at
least two hours at room temperature before
switching on.
– Unpack the unit completely and remove any
stickers that can prevent unit operation.
– Check the unit for damages, do not use the
unit in case of damages.
– Before switching the unit on make sure that
voltage of the mains corresponds to unit
operating voltage.
Accumulator battery (ACC) charging
Full charging of the accumulator battery is
enough for about 45 minutes of continuous unit
operation.
– Insert the power cord (9) connector into the
socket (1) on the hair clipper body or the
base (10) jack (11).
– If you use the base (10), place it on a flat
stable surface, place the hair clipper on the
base.
– Plug the power adapter (9) into the mains
socket, the charging indicator (2) will light
up red.
– Before the first use, charge the ACC dur-
ing 10 hours. Duration of the following ACC
charging should not exceed 8 hours.
– After charging the ACC, unplug the power
adapter (9) and remove the jack-plug of the
cord from the jack (1)/(11).
Note:
– Recharge the ACC only after its complete
discharge.
– Charge the ACC at the temperature from +5°
C to +35° C.
– Never leave the unit connected to the mains
unattended.
– After a long period of non-use (more than
2-3 weeks), charge the ACC completely
before the hair clipper use.
Attachments (6, 7)
– Holding the clamp (8), move the attachment
to the required position.
– Before installing and changing the attach-
ment switch the unit off by pressing the but-
ton (3), if the unit is powered through the
power adapter, unplug it.
VT-2542.indd 5
– By pressing and holding the clamp (8),
remove the attachment from the unit body.
– To install an attachment insert it into the
groove on the rear side of the unit body, then
holding the clamp (8) move it downwards till
bumping and release the clamp (8).
Lubricating oil
– Lubricate the blades after every use of the
hair clipper.
– Use only the oil (12) supplied with the unit.
– Do not use vegetable oil or oil that contains
solvents. Solvents will evaporate, leaving a
thick grease that may slow down the blades
motion.
Operating the hair clipper
– Before the cordless operation of the unit,
charge it completely.
– Install the required attachment (6 or 7) on the
hair clipper body.
Note: For the corded unit operation, insert
the power adapter (9) jack-plug into the jack
(1) and connect the power adapter (9) to the
mains.
– Switch the unit on by pressing the button (3),
the indicator (2) will light up blue.
– After finishing the unit operation switch it off
by pressing the button (3) again.
Note:
Always switch the hair clipper off during the
intervals in operation.
Before changing an attachment, switch the hair
clipper off, and in case of corded unit operation
unplug the power adapter.
Haircutting
– Hair should be clean and dry.
– Before cutting hair switch the hair clipper
on by pressing the button (3), and make
sure that the unit operates normally and the
blades move smoothly. If there is excess oil
on blades, remove it with a dry cloth.
– Switch the unit off by pressing the button (3)
and fix the attachment comb (6).
– Seat the person so that his/her head is
approximately at your eye level, cover the
5
ENGLISH
12.09.2013 17:09:32