Before The First Use - Vitek VT-2568 BK Betriebsanweisung

are not instructed by this person on the
usage of the unit.
•
children or disabled persons are near
the operating unit.
•
For children safety reasons do not leave
polyethylene bags used as a packaging
unattended.
Attention! Do not allow children to play
with polyethylene bags or packaging film.
Danger of suffocation!
•
Do not attempt to repair the unit. Do not
disassemble the unit by yourself, if any
malfunction is detected or after it was
dropped, unplug the unit and apply to any
authorized service center from the con-
tact address list given in the warranty cer-
tificate and on the website www.vitek.ru.
•
To avoid damages, transport the unit in
the original package only.
•
Keep the unit in a dry cool place out of
reach of children and disabled persons.
•
After unit transportation or storage
at low temperature keep it for at
least three hours at room tempera-
ture before switching on.
THIS UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY

BEFORE THE FIRST USE

–
Unpack the unit completely and remove
any stickers that can prevent unit oper-
ation.
–
Check the unit for damages; do not use
it in case of damages.
–
Before connecting the power adapter,
make sure that voltage of the mains
corresponds to unit operating voltage.
–
Charge the battery and lubricate the
blade block following the recommen-
dations below.
The hair clipper can operate both con-
nected to the mains and on the built-in
battery.
M VT-2568.indd 5
Close supervision is necessary when
Battery charging
Full charging of the accumulator battery
is enough approximately for 60 minutes
of continuous operation.
–
Switch the hair clipper off, setting the
power switch (3) to the "OFF" position.
–
Insert the power adapter (9) cord plug
into the connection socket (1) on the
lower side of the unit body.
–
Place the hair clipper on a flat stable
surface.
–
Plug the power adapter (9) plug into the
mains socket, the charging indicator
(2) will light up red.
–
The full charging time for the accumu-
lator battery is 8 hours; do not exceed
it to avoid reducing the battery oper-
ating life.
–
After the battery is charged, unplug
the power adapter (9) from the mains,
remove the adapter cord plug from the
connection socket (1), the charging
indicator (2) will go out.
Attention:- Charge the battery the first
2-3 times for 12 hours. The follow-
ing charging cycles time should not
exceed 8 hours.
–
To prolong the battery operating
life, it should be discharged com-
pletely before each charging cycle.
–
Do not charge the batteries at tem-
perature below +5°C and above
+35°C.
–
If you have not used the hair clipper
for a month or more, charge it com-
pletely before use.
–
Never leave the unit connected to
the mains unattended.
Using the power adapter
The unit connected to the mains is always
ready to use.
If you want to continue using the unit at
partially discharged battery, connect the
plug of the power adapter (9) cord to the
5 5
ENGLISH
05.08.2016 17:02:41