Vitek VT-2568 BK Betriebsanweisung Seite 7

–
For the corded unit operation, insert the
power adapter (9) jack into the socket
(1) on the bottom part of the unit body
and connect the power adapter (9) to
the mains.
Hair cutting
–
The hair should be clean and dry.
–
Before cutting hair, switch the hair clip-
per on, setting the power switch (3) to
the position «ON», the ON indicator (2)
will light up red.
–
Make sure that the hair clipper operates
normally and the blades move smoothly.
If there is excess oil on blades, remove it
with a dry cloth.
–
During operation with the unit connect-
ed to the power adapter, always check
the power cord condition, do not allow
its multiple twisting, periodically turn off
the unit and straighten the power cord.
–
Switch the unit off by setting the switch
(3) to the position «OFF», then install
the universal attachment (6) or (7).
–
Seat a person so that his/her head is
approximately at your eye level, cover
the person's shoulders with a towel and
set hair with the comb (12).
–
Switch the unit on, setting the power
switch (3) to the position «ON», the ON
indicator (2) will light up red.
–
After using set the power switch (3) to
the position «OFF», the ON indicator (2)
will go out.
Notes:
–
Always switch the hair clipper off during
breaks of operation cycles.
–
Before changing the attachment switch
the hair clipper off, and if the hair clip-
per is cord-operated, remove the
power adapter from the mains.
Reminders:
•
Cut off a little amount of hair at a time;
you can always return to the cut part for
additional cutting.
M VT-2568.indd 7
•
The best haircutting results are reached
on dry hair, not wet.
•
Comb the hair with a comb (12) to
reveal uneven locks.
•
It is better to leave longer hair after cut-
ting for the first time.
•
After learning the unit better, you will
be able to arrange your hair in any style
you need.
HAIR STYLING INSTRUCTIONS
Step one
Set the universal attachment (6) to the
position «3» or «6». Switch the hair clip-
per on, setting the power switch (3) to the
position «ON». Hold the hair clipper with
the blades pointed upwards. Start cutting
from the lower part of the head. Slowly
move the hair clipper upwards. Cut the
head back area at the bottom and near the
ears (pic. 9, 10, 11).
Step two
Switch the hair clipper off, set the attach-
ment to the position «9» or «12», switch
the hair clipper on and continue cut-
ting hair closer to the top of the head
(pic. 12).
Step 3 – cutting in the temples area
Switch the hair clipper off, set the
attachment to the position «3» or «6» and
cut hair on the temples. Then set it to the
position «9» or «12» and continue cutting
towards the top of the head.
Step 4 – cutting the crown of the head
Using the universal attachments cut the
hair from the top of the head towards the
crown against the hair growth direction.
•
You can cut hair against and along the
direction of hair growth, but keep in
mind that the hair cut against the growth
will be shorter than the hair cut along
the growth.
7
ENGLISH
05.08.2016 17:02:41