Installation In The Car; Correct Installation - Stokke iZi Sleep by BeSafe Bedienungsanleitung

110

Installation in the car

Important: Correct seat belts
OK
Shoulder belt
This is a 3-point-belt
Make sure that any airbag in
front of the Stokke® iZi Sleep™ by
BeSafe® is deactivated, this means
turning the airbag OFF so it DOES
NOT inflate if you have an accident.
Consult your cars user guide if in
doubt on how to deactivate the
airbag. Make sure that the Stokke®
iZi Sleep™ by BeSafe® is placed in a
rear facing position.
Make sure the carrying handle (10)
is in the carrying position.
Pull the 3-point-belt around the
back of the Stokke® iZi Sleep™ by
BeSafe® and fasten the seat belt
with a 'click' . Make sure the lap
belt of the 3-point-belt is placed
between base (16) and lower seat
shell.
Pull the 3-point-belt through the shoulder belt guide
(12) and belt slot (14), only at the buckle side. Follow the
blue indications on the seat. Tighten the 3-point-belt
firmly around the Stokke® iZi Sleep™ by BeSafe®.
NO
Lap belt
This is a 2-point-belt
10
12
14
Press the handle release buttons
(2)on the inside of the handle and
move the carrying handle (tight-
ener) (10) to the furthest possible
of the two 'safe-to-drive' positions.
For better contact, place the back-
rest of the passenger seat more
upright, if possible.
Check the 'safe-to-drive' indication
(1) on the carrying handle (10),
near the handle release button (2).

Correct installation:

16
2
'Safe-to-drive' indication
'Safe-to-drive' indication
on carrying handle
Positioning in car
Allowed positions in
car, only with
3-point-belt.
don't drive
safe-to-drive
111
1
10
2