Installation - EuroLite TL-3 TCL Bedienungsanleitung

INSTALLATION

WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
The device may be placed directly on the stage floor or rigged in any orientation on a truss without altering
its operation characteristics. The device must never be fixed swinging freely in the room.
1 The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2 Block access below the work area and work from a stable platform when installing the device.
3 Use rigging hardware that is compatible with the structure and capable of bearing the weight of the
device. Please refer to the "Accessories" section for a list of suitable rigging hardware.
4 Mount the device to your trussing system using an appropriate clamp. Use a clamp with M10 or M12
screws - check the mounting threads on the sides of the device.
5 In order to lock the device in any desired position, you need an additional circlip for installation. Screw
the clamp via a M10 or M12 screw, a circlip and a nut onto the mounting thread.
6 Secure the device with a safety bond or other secondary attachment. This secondary safety attachment
must be sufficiently dimensioned in accordance with the latest industrial safety regulations and
constructed in a way that no part of the installation can fall down if the main attachment fails. An
appropriate hole is mounted on the device for fixation of the safety rope. Fasten the safety rope in such a
way that, in the event of a fall, the maximum drop distance of the device will not exceed 20 cm.
7 After installation, the device requires inspections periodically to prevent the possibility of corrosion,
deformation and looseness.
(16) Power output
(17) Safety bond hole
(18) QuickDMX antenna
(19) Power input
(20) Fuseholder
27/40 00125583.DOCX, Version 1.1