Handling; Troubleshooting - Renkforce RF-DAB-IR-1700 Bedienungsanleitung

11. Handling

• Never plug the power plug into a mains socket immediately after the device has been taken from a cold to a warm
environment. The resulting condensation may destroy the device. Allow the device to reach room temperature
before connecting it. Wait until the condensation has evaporated.
• Never disconnect mains adapters from the mains socket by pulling at the cable. Always pull it out of the mains
socket holding it by the contact surfaces provided for this purpose.
• Unplug the mains adapter from the mains socket if you do not use the device for some time.
• For safety reasons, disconnect the mains adapter from the mains socket in case of an electrical storm.
• Do not cover the device and mains adapter to ensure sufficient ventilation. Air circulation also must not be impaired
by any objects like magazines, tablecloths, curtains, etc.

12. Troubleshooting

You are having trouble connecting the radio to your wireless network.
• Check if another device, such as a computer or tablet, can access the internet through the WLAN-network.
• Check if your router's DHCP server is running, whether the static IP address is properly configured with the entire
configuration (subnet mask, standard gateway) in the radio.
• Ensure that your firewall isn't blocking the necessary outbound ports.
• Some access points are configured not to admit any new devices as long as their MAC address has not been
entered on the configuration page in the access point. For this, observe the manual of your access point or router.
You can find the MAC address as follows:
"Information" > "Netzwork Information" > "WiFi MAC" (WLAN MAC address) or "LAN MAC" (MAC address for
connection via network cable)
• Check if the right WLAN password has been entered. Observe capitalisation.
The radio is connected to your network but does not play specific stations:
• The radio station may not be broadcasting right now. This may be connected to different time zones as well.
• It is possible that too many visitors are trying to access the station's server at the same time. This may cause an
overload.
• It is also possible that only a specific number of users may access the server at a time, and that this number has
currently been reached.
• It is possible that the station does not broadcast at all anymore.
66