Electrical Connection - Electrolux ERT1605AOW Benutzerhandbuch

3
1
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natu-
ral fitting of the gasket.
In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The After
Sales Service specialist will carry out the re-
versibility of the doors at your cost.

9.5 Electrical connection

Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power sup-
ply.
The appliance must be earthed. The power
supply cable plug is provided with a con-
tact for this purpose. If the domestic power
1
2
2
• Unscrew the screws of the door top
hinge.
• Remove the hinge. Put over the pin in
the direction of the arrow. Install the
hinge on the opposite side.
• Tighten the hinge.
• Put the top in position.
• Pull it forward.
• Screw both screws on the rear side.
• Remove and install the handle (if foree-
sen) on the opposite side.
• Reposition, level the appliance, wait for
at least four hours and then connect it to
the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
supply socket is not earthed, connect the
appliance to a separate earth in compli-
ance with current regulations, consulting a
qualified electrician.
The manufacturer declines all responsibility
if the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Di-
rectives.
ENGLISH 27