Electrical Connection; Prior To Inital Start-Up; Control Panel - Electrolux SANTO 72390-6 KA Benutzerinformation

Electrical connection

Before initial start-up, refer to the appliance rating plate to ascertain if
supply voltage and current values correspond with those of the mains at the
installation location.
e.g.:
(i.e. 230 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance on the left.
A correctly installed, earthed socket is required for the electrical supply. The
supply must have a fuse rating of at least 10 Amps.
If the socket is not accessible once the appliance is built in, the electrical
installation must include suitable means of isolating the appliance from the
mains (e.g. fuse, cut-out, current trip or similar with a minimum contact
separation of 3 mm).
Attention: it must be possible to disconnect the appliance from the mains
power supply; the plug must therefore be aesily accessible after the
installation.
Attention: If the supply cord is damaged, it must be replaced by a special
cord or assembly available from the manufacturer or its Service Agent.
Prior to Initial Start–Up
• Please clean the appliance interior and all accessories prior to initial start-
up (see section: "Cleaning and Care").

Control panel

A. Button ON/OFF
B. Temperature setting button (for warmer temperatures)
C. Temperature display
D. Temperature setting button (for colder temperatures)
E. COOLMATIC function and COOLMATIC indicator (yellow)
F ALARM OFF button and red warning light
72
AC 230 ... 240 V
230 ... 240 V~ 50 Hz
A B C D E
50 Hz or
F