Electrolux ERT1605AOW Benutzerhandbuch Seite 23

Problem
The appliance is
noisy
The appliance does
not operate. The
lamp does not oper-
ate.
The lamp does not
work.
The compressor op-
erates continually.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Water flows on the
ground.
The temperature in
the appliance is too
low.
Possible cause
The appliance is not sup-
ported properly
The appliance is switched
off.
The mains plug is not con-
nected to the mains socket
correctly.
The appliance has no pow-
er. There is no voltage in
the mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set
correctly.
The door is not closed cor-
rectly.
The door has been opened
too frequently.
The product temperature is
too high.
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clogged. Clean the water outlet.
Products prevent that wa-
ter flows into the water col-
lector.
The melting water outlet
does not flow in the evapo-
rative tray above the com-
pressor.
The temperature regulator
is not set correctly.
ENGLISH
Solution
Check if the appliance
stands stable (all the four
feet should be on the floor)
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electrical
appliance to the mains sock-
et.
Contact a qualified electri-
cian.
Close and open the door.
Refer to "Replacing the
lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open
longer than necessary.
Let the product temperature
decrease to room tempera-
ture before storage.
Decrease the room temper-
ature.
This is correct.
Make sure that products do
not touch the rear plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
23