Restoring Factory Settings - Farho NOVA LITTLE Gebrauchsanweisung

Customizing the PIN code
If you have just activated the PIN code, follow the stages de-
scribed below.
Alternatively, you must copy the steps 1 and 2 of the initialisation
process as well as the steps 1 and 2 of the activation process
before personalising the PIN code.
Please remember that the personalisation of the PIN code can
only be set once the initialisation and activation of the PIN code
has been completed.
2÷
1- When appears, press for at least 5 seconds.
2- The 0000 code appears and the first number blinks. Press
or to select the first desired number then press
save and exit. Repeat this operation for remaining 3 numbers.
3- Press to confirm. The new code is now saved.
4- Press again on to exit setting PIN code mode and go
back to the home display of the installer settings.
To exit the Installer settings, press

RESTORING FACTORY SETTINGS

If the PIN code protection is disabled, the user and installer settings
are re-initialized:
1- From the PIN code setting, press
on the display.
÷2
2-
÷2
3- Press the key
configuration and goes back automatically to the home dis-
play of the installer settings.
5 sec.
to
The following factory values will be effective:
Comfort setting temperature 19°C
Boost duration
Keypad lock
Backlighting
Eco mode temperature
lowering-level
Frost protection temperature 7°C
Minimum set of Comfort
setting temperature
Maximum set of Comfort
setting temperature
Maximal Boost duration
Maximum ambient
temperature for the automatic
stop of the Boost
Temperature unit
Automatic open window
twice.
detection
PIN code protection
Value of the PIN code
To exit the installer settings, press
« W
. appears briefly
15 23
appears. Press or to select
= Factory settings reset
= Factory settings not reset
for 5 seconds. The device returns to its initial
Settings Factory settings
Operating
60 min.
Disabled
User settings
L3
-3,5°C
7°C
30°C
60 min.
35°C
°C
Installer settings
Enabled
Disabled
0000
twice.
.
sec.
15