Farho NOVA LITTLE Gebrauchsanweisung Seite 15

4- The cursor above the number 1 (which represents the
Monday) will flash. Select the date using
Save by pressing .
1
5- To change and/or allocate programmes press
the setting the time and day mode, press
Choices programmes
Schematic sequence of programmes:
Your device's default setting is non-stop Comfort for 7 days a
week.
Programmes overview
- Comfort: your device will operate in Comfort mode, 24 hours a
day, as regards each day selected.
Note: You can set the Comfort mode temperature to the tem-
perature you require (see Setting the comfort mode tempera-
ture page 6).
- Eco: The device will operate 24 hours a day in Eco mode.
Note: You can set the temperature-lowering parameters
Setting the Eco mode temperature lowering-level page
- P1: your device will operate in Comfort mode from 06:00 to
22:00 (and in Eco mode from 22:00 to 06:00).
- P2: your device will operate in Comfort mode from 06:00 to
09:00 and from 16:00 to 22:00 (and in Eco mode from 09:00 to
16:00 and from 22:00 to 06:00).
- P3: your device will operate in Comfort mode from 06:00 to
08:00, from 12:00 to 14:00 and from 18:00 to 23:00 (and in Eco
mode from 23:00 to 06:00, from 08:00 to 12:00 and from 14:00
to 18:00).
Potential modifications of programmes
If the default time schedules for the P1, P2 and P3 programmes
does not suit your routines, you can change them.
Modifying the P1, P2 or P3 programmes.
If you modify the time schedules for the P1, P2 or P3 programmes,
the schedules will be modified for all the days of the week for
which P1, P2 or P3 had been set.
1- If you just set the time and day, go to step 2.
From Auto, Comfort, Eco or Frost protection mode, press
for 5 seconds.
When the cursor moves above the setting time symbol
press shortly.
2- Press or
or .
3- With or
P1 will flash. Press
. To exit
3 times.
4- The P1 start time (which by default is 06:00) will flash.
Using or
of 30 minutes.
(see
11).
Save by pressing
5- The P1 end time (which by default is 22:00) will flash. Using
or
minutes.
Save by pressing
6- Press
to exit the programming Mode and return to Auto
Mode.
,
Note: without action on the keys, it will return to Auto after a few
minutes.
7 15
. The cursor moves above prog.
1
, select P1.
for 5 seconds to make changes.
1
1
5 sec.
, you can change this time, by increments
.
, you can change this time, by increments of 30
.
2
7