Specifications - Makita AN635H Betriebsanleitung

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
Air pressure
Wire-collated coil nail
Sheet-collated coil nail
Minimum hose diameter
Pneumatic tool oil
Dimensions (L x W x H)
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
Wear safety glasses.
Wear ear protection.
The tool has the capability of operating in
contact actuation mode.
Do not use on scaffoldings, ladders.
Intended use
The tool is intended for the preliminary interior work
such as fixing floor joists or common rafters and framing
work in 2" x 4" housing.
The tool is for high-volume professional application
only. Do not use it for any other purpose. It is not
designed to drive fasteners directly on a hard surface
like steel and concrete.
Nail length
Nail diameter
Nail capacity
Nail length
Nail diameter
Nail capacity
1.18 - 2.26 MPa (11.8 - 22.6 bar)
ISO VG32 or equivalent
297 mm x 125 mm x 296 mm
Noise
The typical A-weighted noise level determined accord-
ing to EN ISO 11148-13:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
Vibration
The vibration total value determined according to EN
ISO 11148-13:
Vibration emission (a
Uncertainty (K) : 1.5 m/s
7 ENGLISH
AN635H
32 mm - 65 mm
2.1 mm - 3.3 mm
200 pcs - 400 pcs
32 mm - 65 mm
2.2 mm - 2.9 mm
200 pcs
4.0 mm
2.2 kg
) : 83 dB(A)
pA
) : 96 dB (A)
WA
2
) : 4.0 m/s
h
2