Connections, Operating And Display Elements - Cameo CLPSTDTW Bedienungsanleitung

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

1
POWER IN
Neutrik powerCON power input socket for power supply to the device. A suitable power cable is included.
2
POWER OUT
Neutrik powerCON power output socket for the power supply of additional CAMEO spotlights. Ensure that the total current consumption of
all connected devices does not exceed the value specified on the device in amperes (A).
3
FUSE
Fuse holder. Fuse T2AL/250 V (5 x 20mm). IMPORTANT: Replace the fuse only with a fuse of the same type and value. In the event of repeated
fuse failure, please contact an authorised service centre.
4
DMX IN
Male 3-pin XLR socket for connection to a DMX control device (e.g. DMX console).
5
DMX OUT
Female 3-pin XLR socket for sending the DMX control signal.
6 LC DISPLAY
Illuminated LC display shows currently active mode and the menu items in the Edit menu.
7 CONTROL BUTTONS
MODE – press MODE to access the selection menu for system settings. Press repeatedly to go back to the main display. ENTER – press
ENTER to access the menu levels to make value changes, and to access the sub-menus. Confirm value changes by pressing ENTER. UP and
DOWN – select individual menu items in the selection menu (system settings, operating mode etc.) and in the sub-menus. and to change a
value, such as the DMX address.
8
EYELET FOR SECURING CABLE
Overhead installation must only be carried out by qualified personnel. A suitable safety cable must be fitted to the floodlight's eyelet to
ensure that it does not fall down.
4
1
3
6
7
5
2
8
5