English
(3) Rem ove the end of the pig-tail on the carbon brush
from the term inal section of brush holder and then
rem ove the carbon brush from the brush holder.
<Assem bly>
(1) Insert the end of the pig-tail of the carbon brush
in the term inal section of brush holder.
(2) Insert the carbon brush in the brush holder.
(3) Use the auxiliary hexagonal w rench or sm all
screw driver to return the edge of the spring to the
head of the carbon brush.
(4) M ount the tail cover and tighten the D4 tapping
screw .
5. M aintenance of the motor
The m otor unit w inding is the very " heart" of the
pow er tool. Exercise due care to ensure the w inding
does not becom e dam aged and/or w et w ith oil or
w ater.
6. Service parts list
CAUTION:
Repair, m odification and inspection of Hitachi Pow er
Tools m ust be carried out by an Hitachi Authorized
Service Center.
This Parts List w ill be helpful if presented w ith the
tool to the Hitachi Authorized Service Center w hen
requesting repair or other m aintenance.
In the operation and m aintenance of pow er tools,
the safety regulations and standards prescribed in
each country m ust be observed.
M ODIFICATIONS:
Hitachi Pow er Tools are constantly being im proved
and m odified to incorporate the latest technological
advancem ents.
Accordingly, som e parts m ay be changed w ithout
prior notice.
NOTE:
Due to HITACHI's continuing program of research and
developm ent, the specifications herein are subject to
change w ithout prior notice.
Information concerning airborne noise and vibration
The m easured values w ere determ ined according to
EN 60745 and declared in accordance w ith ISO 4871.
G18 series
M easured A-w eighted sound pow er level: 100 dB(A)
M easured A-w eighted sound pressure level: 89 dB(A)
Uncertainty KpA: 3 dB(A)
G23 series
M easured A-w eighted sound pow er level: 101 dB(A)
M easured A-w eighted sound pressure level: 90 dB(A)
Uncertainty KpA: 3 dB(A)
Wear ear protection.
The typical w eighted root m ean square acceleration
value: 2.5 m /s
2
.
8
Information about pow er supply system of nominal
voltage 230 V~ (For G18SCY, G18SEY, G23SCY,
G23SEY only)
Under unfavorable m ains conditions, this pow er tool m ay
cause transient voltage drops or interfering voltage
fluctuations .
This pow er tool is intended for the connection to a pow er
supply system w ith a m axim um perm issible system
im pedance Z
of 0.23 Ohm at the interface point (pow er
M AX
service box) of the user's supply.
The user has to ensure that this pow er tool is connected
only to a pow er supply system w hich fulfills the
requirem ent above.
If necessary, the user can ask the public pow er supply
com pany for the system im pedance at the interface
point.