Installation; Installing The Aluminium Stands; Wall Mounting - Silvercrest IAN 322642_1901 Bedienungs- Und Sicherheitshinweise

Installation


Notice: The electric towel warmer can be operated
both as a freestanding device and as a wall-mounted
device.

Installing the aluminium stands


A
Attach the decorative caps
sponding openings on the top of the device.
(See fig.A) Attach the surface protectors
the ends of the aluminium stands
B
Now assemble the aluminium stands
the four M3.5 x 12 mm Phillips screws
vided to attach the aluminium stands. (See fig.B)

Wall mounting


ATTENTION! RISK OF DEATH, PERSONAL
INJURY AND DAMAGE TO PROPERTY!
Read your drill's operating and safety instructions
carefully.
RISK OF FATAL INJURY!
Take care to avoid hitting electricity, gas or water
pipes when drilling into the wall. If necessary,
check with a cable detector before drilling into a
wall.
C
to the corre-
1
D
to
6
.
5
, using
5
pro-
8
Place the wall brackets
desired position. Figure C shows an example of
how to position the wall brackets.
E
Now measure the distance between the holes
found on the four wall brackets
These are the measurements for distances be-
tween the holes to be drilled. Alternatively, you
can place the electric towel warmer in the desired
position on the wall and mark the locations of the
holes to be drilled directly on the wall through the
holes in the wall brackets
Please note the dimensions of the eight en-
closed screws before drilling. Drill the holes
9
(Ø 6mm, 28mm length) in the wall where you
would like to mount the electric towel warmer.
After the drill holes have been cleaned of any
dirt, insert the dowels
7
on the product in your
2
. (See Fig. D)
2
. (See Fig. E)
2
into the drill holes.
GB/IE/NI 19