Jacuzzi J-400 Serie Vorinstallationsblatt Seite 17

It is the responsibility of the installer/owner to ascertain com-
pliance with specific local regulations prior to installation.
Jacuzzi Europe S.p.A. gives no guarantee in this respect and
refuses all responsibility regarding compliance of the instal-
lation carried out.
Technical Features
The Jacuzzi spas feature a single-phase power supply (220-240
V). All electro-mechanical parts and pipes are enclosed.
- J-415 spas are equipped with 1 hydromassage pump plus a re-
circulation pump.
- J-425/435/445/465/470/480 spas are equipped with 2 hydro-
massage pumps plus a recirculation pump.
- J-495 spas are equipped with 3 hydromassage pumps plus a
recirculation pump.
Maximum absorption of the system
The electrical system that powers the spa must absolutely be
sized for maximum consumption (as shown in the table).
Power supply
(single-phase)
Volt
J-415 220-240 ~
J-425 220-240 ~
J-435 220-240 ~
J-445 220-240 ~
J-465 220-240 ~
J-470 220-240 ~
J-480 220-240 ~
J-495 220-240 ~
(k): a 230V (single-phase) / (j): max. power absorption
If sufficient electrical energy is not available, an electronic energy
consumption limiter can be activated from inside the electronics box.
This operation can only be performed by authorized Jacuzzi®
technicians and limits electricity consumption as follows:
- J-415
Alternative consumption: 3.5kW/15A (by activating a pump, the
electric heater switches off).
- J-425/J-435/J-445/J-465/J-470/J-480
Alternative consumption: 3.9kW/17A (by activating a pump, the
electric heater switches off).
- J-495
Alternative consumption: 6.7kW/29A (by activating three pumps,
the electric heater switches off).
Tot. Consumption:
electric heater + pump(s)
Hertz Ampere
(k)
50 22
(k)
50 29
(k)
50 29
(k)
50 29
50 29 (k)
50 29 (k)
50 29 (k)
50 36 (k)
Weights
net weight
kg
J-415 ~ 265
J-425 ~ 361
J-435 ~ 373
J-445 ~ 281
J-465 ~ 411
J-470 ~ 431
J-480 ~ 454
J-495 ~ 517
User safety
The system, if installed by qualified personnel, does not pres-
ent any hazard for the user. Safety is however also contingent
upon proper use, as set forth by the user's manual included with
the product. The user must contact qualified personnel for spe-
cial operations described in the manual.
It is important to make sure that personnel tasked to install
and manage the system are qualified as per legal requirements in
effect in the country where installation is carried out.
kW
(j)
5,1
This appliance uses and generates radio waves: if it is not in-
stalled and used as directed, it may cause interference with the
(j)
6,7
reception of radio and television programs.
(j)
6,7
However, in special cases this may happen even if the directions
(j)
6,7
provided are followed.
6,7 (j)
6,7 (j)
6,7 (j)
8,3 (j)
Positioning the Jacuzzi® remote monitoring
system
Check the power level of your domestic Wi-Fi router in the loca-
tion where you want to install the spa.
If the router's Wi-Fi signal is strong (3-4 bars) and internet access
is stable, it is an optimal location to install the spa. If it is weak, it
may be necessary to select another position or install a "repeater"
to make the signal stronger.
Refer to the relative user and maintenance manual.
Set up for installation
The site where the spa will be installed must be de-
signed to ensure the possible removal and reloca-
tion of the spa itself, if necessary.
17
average fill maximum total
water volume max. weight
litres litres kg
~ 871 ~ 1098 ~ 1363
~ 1287 ~ 1628 ~ 1989
~ 1363 ~ 1666 ~ 2039
~ 1401 ~ 1722 ~ 2003
~ 1552 ~ 1931 ~ 2342
~ 1703 ~ 2120 ~ 2551
~ 1817 ~ 2271 ~ 2725
~ 1968 ~ 2347 ~ 2864
support load concentrated
area on support area
m2 kg/m2
~ 2,86 ~ 476
~ 3,30 ~ 602
~ 4 ~ 510
~ 4 ~ 500
~ 3,40 ~ 688
~ 4,13 ~ 618
~ 4,2 ~ 648
~ 5,12 ~ 559