Warranty Conditions - Messner Allrounder Bedienungsanleitung

4. Note: The underwater floodlights should be installed about 2 cm under
the water. This way, the floodlight glass is constantly rinsed clean by the
water. If desired, the floodlights can be provided with color disks (Item 9
to 12). Snap the six projections of the color disk onto the floodlight ring
at the corresponding depth.
List of parts supplied / Spare parts
Item Name
1 Underwater floodlight 100 W
2 Transformer 105 VA 230 V/12 V
3 Floodlight bracket 370
4 Hexagonal screw A2 M8 x 20
5 Hexagonal screw A2 M6 x 25
6 Hexagonal nut A4 M6
7 Lock washer A2 Form A Ø 6,4
8 Stand UWL 12100
9 Red disk UWL 12100
10 Blue disk UWL 12100
11 Green disk UWL 12100
12 Orange disk UWL 12100
Safety precautions
Attention: Please follow the safety precautions given in the manuals!
Set the Allrounder with Float Set and/or Stand Set in the desired position in
the pond and horizontally align the equipment by shifting the stand and/or
float bars. Consider the immersion depth required for the selected fountain
nozzle! See also Stand Set/Float Set assembly!
The Allrounder with Float Set can be set in the desired location in the pond
by using a rope from the bank of the pond or an "anchor" (heavy stone).
1. Connect the pump's power supply plugs to the electricity mains.
Attention: The pump stars immediately and should not run "dry".
Otherwise, the equipment may be damaged.
2. Connect the underwater floodlight's power supply plugs to the electricity
mains.
16
Art. no. Count
170/003061 3
118/000046 3
104/003283 3
114/000064 3
114/000038 9
114/000013 9
114/000037 9
104/001141 3
104/001143 3
104/001144 3
104/001145 3
104/001146 3
Attention: The operation of the Allrounder should be checked regularly. See
Maintenance.
Pump and Underwater floodlight maintenance
For maintenance, cleaning, light replacement, or winter storage, please follow
the instructions given in the enclosed manuals.
Allrounder Maintenance
Along with water, waste such as grass, leaves, etc., will be sucked into the fil-
ter, which can clog the filter, depending on the accumulation of debris. If the
fountain does not reach the given height, the filter ring may get clogged. The
filter ring should be cleaned regularly. The pump should also be cleaned at
regular intervals. See pump operating instructions.
Cleaning the filter ring
1. The filter ring must be checked regularly for cleanliness.
2. The time intervals depend on the level of contamination.
3. Using a garden hose, rinse off the dirt that has settled on the filter ring.
Winter maintenance
Ice and frost can damage the Allrounder! In order to prevent damage, the
Allrounder must be emptied and cleaned in the autumn (see Allrounder
Cleaning). Store all parts in a frost-free area during the winter months.

WARRANTY CONDITIONS

This equipment comes with a twenty four month warranty (excluding lighting
materials), which begins on the day of delivery. The sales slip is considered
as proof of purchase for this warranty. We will repair damages based on
material or processing errors within the warranty period free of charge, or
replace the damaged parts, at our discretion. Damages resulting from instal-
lation and operation errors, lime deposits, defective maintenance, frost, nor-
mal wear, or inappropriate attempts to repair the equipment are not covered
by this warranty. For changes to the equipment, such as shortening the
power connection cords or power plugs, the warranty expires. We are not
liable for damages resulting from a power loss to the equipment or inappro-
priate use. In case of a warranty claim, please send the equipment to us, with
proof of purchase, through the distributor where you purchased the equip-
ment, free of charge.
17