Klarstein Eliana Bedienungsanleitung Seite 30

EN
30
Cleaning the grease filters
• The mesh filters can be cleaned by
hand. Let the filters soak for about
3 minutes in water with a grease-
loosening detergent, then brush
them gently with a soft brush. Do
not apply too much pressure to
avoid damaging it. Leave to dry
naturally, avoid direct sun light.
• Filters should be washed
separately to crockery and kitchen
utensils. Do not use rinse aid for
cleaning.
Installing grease filters
Install the grease filters in four steps (see figure below):
1. Angle the filter into slots at the back of the hood.
2. Push the button on the handle of the filter.
3. Release the handle once the filter fits into a resting position.
4. Repeat the previous steps to install all filters.
Insert and replace activated carbon filter (optional)
Note: An activated carbon filter is not included. But you can buy it in addition to the
cooker hood.
Activated carbon filters can be used to bind odours. Normally the activated carbon filter
should be replaced after 3 or 6 months, depending on cooking habits.
Install the activated carbon filter as described below:
1. Before installing or replacing the activated carbon filter, disconnect the appliance
from the power supply.