Before First Use; Assembly - Silvercrest SSMW 750 D1 Bedienungs- Und Sicherheitshinweise

Cleaning and storage
m WARNING! Risk of injury!
Disconnect the product from the
power supply before cleaning
work and when not in use .
Do not store the hot product in a
cupboard or in the packaging .
Do not pull the power plug out of
the electrical outlet by the power
cord .
Protect the product, its power
cord and power plug against
dust, direct sunlight, dripping and
splashing water .
Store the product in a cool, dry
place, protected from moisture
and out of the reach of children .
Protect the product against heat .
Do not place the product close to
open flames or heat sources such
as stoves or heating appliances .
˜ Before first use
Remove the packaging . Check if all parts are
complete .
During production, some parts are covered with a
thin oil film for their protection .
10 GB/CY
Before first use, operate the product without any
food so that any potential residues evaporate .
Clean the product and its accessories (see the
"Cleaning and care" section) .
NOTES:
The first few times the product is heated up, a
faint odour may be present . Ensure sufficient
ventilation in the area .
Discard the first set of waffles .
˜ Assembly
m
WARNING! Risk of electric shock. Before
installing/removing the plates 11, 12, 13:
Disconnect the power plug 4 from the wall
outlet .
DANGER! Risk of burns. Do not change/
remove the plates 11, 12, 13 right after
operation . Let the product cool first .
Installing the plates
Open the lock 1 . Open the product .
Place the inner catch 10 of the chosen plate into
the large hook catches 7 .
Push down the plate until it clicks in place .
Repeat on the other side of the product .
NOTE: Install only plates of the same type .
Removing the plates
Open the lock 1 . Open the product .
Pull the release levers 8 . Remove the plate .
Repeat on the other side of the product .