Installation On A Wall Using A Screw/Peg; Operation; Adjusting The Motion Sensor - FLORABEST HG00249 Bedienungs- Und Sicherheitshinweise

Installation on a wall using a screw/peg

Use the enclosed peg
the device on a wall. This installation material is intended for a
normal wall. If the wall you wish to install the device on has a
different consistency, check with a specialist to find out which
material is suitable for installation on your wall.
Ensure the screw
Allow the screw to protrude approx. 1 cm from the wall and
use the loop

Operation

The device has two adjustment options:

Adjusting the motion sensor

The sensitivity of the sensor can be adjusted using the sensitivity
controller . This affects the range and the size of the animal that
2
can be detected:
To detect small animals the size of a rodent (e.g. mice) turn the
sensitivity controller to the „max." position. The range for detecting
small animals like these is approx. 2 m.
If you only want to detect larger animals (e.g. dogs or foxes) and
not smaller animals, turn the sensitivity controller anticlockwise
16 GB
(Ø 6 mm) and the screw
17
is a maximum of 1.5 m above the ground.
16
to hang the device on the screw.
7
to install
16