Installation On A Wall Using A Screw / Peg; Operation; Adjusting The Motion Sensor; Adjusting The Signal Frequency - FLORABEST HG00249 Bedienungs- Und Sicherheitshinweise

Installation on a wall using a screw / peg

Use the enclosed peg
the product on a wall. This installation material is intended for a
normal wall. If the wall you wish to install the product on has a
different consistency, check with a specialist to find out which
material is suitable for installation on your wall.
Ensure the screw
Allow the screw to protrude approx. 1 cm from the wall and
use the loop

Operation

The product has two adjustment options:

Adjusting the motion sensor

The sensitivity of the sensor can be adjusted using the sensitivity con-
troller . If a movement is detected, a signal / flash sounds /
2
shines approx. 30 sec. Adjust to MAX position, the detection
range approx. 8 m.

Adjusting the signal frequency

The product has 5 different programmes to repel certain kinds of
animals.
(Ø 6 mm) and the screw
18
is a maximum of 1.5 m above the ground.
17
to hang the product on the screw.
7
to install
17
GB/IE/NI 17