Operation; Maintenance; Troubleshooting - OHAUS VF Serie Bedienungsanleitung

3. OPERATION

Operating Limits

Although the weighing platforms have extremely rugged construction, certain load limits must not be exceeded.

Depending on the type of loading, the maximum safe static load, i.e. the maximum admissible loading is:

4. MAINTENANCE

4.1 Cleaning
WARNING: Electric Shock Hazard. Disconnect the equipment from the power supply before cleaning.
Make sure that no liquid enters the interior of the instrument.
Attention: Do not use solvents, harsh chemicals, ammonia or abrasive cleaning agents.
The exterior surfaces of the instrument may be cleaned with a cloth dampened with water and a mild detergent.

4.2 Troubleshooting

For technical issues contact an Authorized Ohaus Service Agent. Please visit our website www.ohaus.com to locate the Ohaus office
nearest you.
Model
VF...-CS/DS300
VF...-CS/DS/E/ES600

Avoid falling loads, shocks and lateral impacts!

The load plate of the weighing platform is the active weighing
component, the approach ramps are passive, i.e. in the weighing
operation all wheels of the conveying vehicle must be on the
load plate.

The air gap between load plate and the approach ramps must be
free. It is thus essential, particularly when weighing granular or
small sized weighing samples, to check the gap at regular
intervals and keep it free.
(1) Maximum (2) Maximum
Central Load Side Load
1000 800
3000 2000
EN-3
(3) One Side
Corner Load
400
1000