OHAUS VF Serie Bedienungsanleitung Seite 4

EN-2
Certifiable Application
or
or
Non-certifiable Application
The weighing platform can also be operated without ramps or foot plates in case of non-certifiable applications.
Connecting the Indicator
1) Route the load cell connection cable to the indicator.
Caution: Ensure the connection cable is protected against possible damage when routed to the indicator.
2) Consult the installation instructions of the indicator for the steps involved in attaching the indicator (if not
already connected).
3) Connect the load cell connection cable to the indicator in accordance with the following table:
1)
2)
3)
4)
5)
6)
Indicator
EXC+ (IN+)
SEN+
SIG+ (OUT+)
SIG- (OUT-)
SEN-
EXC- (IN-)
Depending on the model, the following
accessories must be available when
setting up the weighing platform:
 2 approach ramps
or
 1 approach ramp and 1 set of foot plates
or
 2 sets of foot plates
Place approach ramps and/or foot plates on the floor in front of and
behind the weighing platform.
Lift weighing platform and position the levelling feet in the slots
provided in the ramps or foot plates.
Ensure the surface is completely flat in the area of the scale location,
especially in the region of the levelling feet, and the foot plates and
ramps are positioned horizontally. Small differences in height can be
compensated by the adjustable feet.
Align ramps and foot plates.
Mark position of the ramps and foot plates. It is essential to fix them
to the floor through drill holes using the dowels provided (foot plates:
2 dowels each, ramp: 2 dowels each).
Color
Grey
Yellow
White
Brown
Green
Blue