Control Panel - Jacobsen AR522 Handbuch Für Vertriebspartner

2.3

CONTROL PANEL _________________________________________________________

L. Horn Switch
This switch is used sound the horn.
M. Warning Lights
When ignition switch (U) is turned to RUN
position, glow plug light indicates that the glow
plugs are energized. Wait until light goes out
to start the engine.
N. Mower Lift lever
The mower lift lever raises and lowers
the mowers and operates in either
automatic or manual mode. Push lever
forward to lower mowers, pull back to
raise mowers.
Manual Mode - Set mow switch (Q) in its OFF
(down) position. In this position all mowers will raise
or lower while pressure is applied to the lift lever.
Automatic Mode - Set mow switch (Q) in its ON (up)
position. In automatic mode the mowers will lower
and start automatically with a momentary forward
movement of the lift lever. In this mode mowers will
only raise to a "crosscut" position with a momentary
backward movement of the lift lever.
To raise mowers to their transport position, hold lever
until mowers are fully raised.
NOTICE
While in an Automatic Mode lift or lower cycle, which
lasts approximately 3 seconds, moving the lift lever in
the opposite direction will turn all mowers off, and
manual mode will start for the position selected.
P. PTO Switch
The PTO switch is a 2-position knob type
switch used to engage and disengage the
mowers. It also sets the mower lift lever (P) in
manual or automatic mode. Set PTO switch
in its disengaged (down) position when
starting the mower.
When the PTO switch is in the engaged (UP)
position, the traction control system is automatically
enabled, and the lift lever is placed in Automatic
Mode.
R. Light Switch
Controls operation of work lights. Press front of
switch to turn lights on. Press rear portion of
switch to turn lights off.
S. Traction Control
Press and release switch to enable controller
traction control system. This system reduces
down pressure on decks by pulsing the lift
circuit, transferring
Reducing down pressure improves traction,
but may cause decks to float up creating an
uneven cut. Light on switch will be on when system is
active.
Press and release switch again to deactivate traction
control. This will reduce traction, but improves deck
contact with ground.
The traction control system is automatically enabled
when the PTO switch is placed in the engaged (UP)
position. Press and release traction control switch to
cancel traction control.
T. Engine Throttle
Controls engine speed. Run machine at full throttle
during normal machine operation.
U. Ignition Switch
The ignition switch has three positions.
OFF- RUN (ON) - START. In the RUN
position the controller program is running
and input and output circuits are being
monitored. See Section 6.2.
V. Combination Gauge
Used to display fuel level, operating hours, and
indicate mower alerts. See Section 2.4.
W. Parking Brake Switch
To engage parking brake, slide lock forward
and depress top of switch. Parking brake light
on combination gauge (V) will turn on. Normal
reel operation is disabled with parking brake
engaged.
To disengage parking brake, depress rear of switch.
Parking brake light on combination gauge will turn
off.
NOTE: Mower will not start with parking brake switch
in the Disengaged position.
CONTROLS
weight to mower.
11
2