Alarm Clock Volume; Timer - Imperial DABMAN i450CD Bedienungsanleitung

7. SETTINGS

7.1.5.2. Alarm clock volume

Under Alarm Volume, set the volume for the alarm signal.
Use the ▼▲ buttons on the remote control in the Settings menu
E
to select the Alarm clock and press the ENTER button on the
remote control or confirm with the ENTER button on the unit.
Select the Alarm Volume line and press ENTER on the remote
control to confirm with the ENTER button on the unit.
Adjust the desired volume using the VOL+ buttons on the remote
control or on the
unit.

7.1.6. Timer

You can use the timer to set a time after which the radio triggers
an alarm.
Use the ▼▲ buttons on the remote control in the
settings menu to select the Timer and press the ENTER button
on the remote or confirm with the ENTER button on the device.
Specify the time in minutes and seconds using the ▸ ◂ buttons.
Increase or decrease the time in increments of seconds by
pressing incrementally. Press and hold the ▸ or ◂ button to speed
up the time change in both directions.
After confirming the entry with ENTER on the remote control or
by pressing the ENTER button on the unit, the timer becomes
active. An alarm signal sounds after the set time elapses.
The timer can be interrupted with the ENTER button on the re-
mote control or by pressing the ENTER button on the unit. The
timer alarm can also be stopped with these buttons.
Operating Manual 152