Mark BaseTherm Technisches Handbuch Seite 6

– Mount the BaseTherm to the wall while observing the instructions in section 4.2 Positioning
the thermostat.
– Connect the BaseTherm in accordance with the electrical diagrams at the back of this technical
documentation [2] [3].
When making the connections to the air heaters, please also refer to the technical
documentation for the air heaters.
NB!
The following applies when connecting multiple appliances to 1 thermostat.
When multiple appliances are connected to a single thermostat, the appliances must be given an
address.
This is done by setting the dip-switches and switch S4 on the burner control box. You must also
ensure that the appliance to which the BaseTherm is connected is always addressed as appliance
1 [4].
Refer to figure [5] for the correct settings for the dip-switches and switch S4.
– After completing connection and installation, switch the supply voltage back on.
Refer to the air heater technical documentation for the relevant instructions.
6