Floor Sensor Calibration - STIEBEL ELTRON RFT-TC Benutzerhandbuch

Floor Sensor Calibration*

Mon 11:15
23.5
°
17:00
Manual Other...
Mon 11:15 Actual Floor Temp.
1
24.3°
23.5
°
17:00
6 7 6
Manual Other...
Heating Schedule Heating Schedule
Adaptive Function
Energy Use Energy Use Heating Schedule
Open Window
User Settings Energy Use
User Settings
Floor sensor calibrated
2
Adaptive Function
Sensor Application
Engineer Settings Engineer Settings User Settings
Sensor Type Open Window
Engineer Settings
Floor Sens. Calibr. Sensor Application
Room Sens. Calibr. Sensor Type Adaptive Function
3
Temp. Scale Floor Sens. Calibr. Open Window
Factory Reset Room Sens. Calibr. Sensor Application
Sensor Type Temp. Scale
Floor Sens. Calibr.
Factory Reset
Current reading from
Room Sens. Calibr.
floor sensor is
23.2°
Temp. Scale
Calibrate sensor?
Factory Reset
4
PAGE 49
© 2018 OJ Electronics A/S
This option allows you to calibrate the floor sensor .
1
You should calibrate the sensor if the temperature reading differs from the actual
floor temperature .
Note that changes in the floor sensor characteristics may damage certain floors .
You can calibrate the sensor with +/- 10°C in steps of 0 .5°C in the following way:
1 . Tap the "Menu" button on the home screen .
2 . Then tap the "Engineer Settings" button .
3 . Scroll down and tap the "Floor Sensor Calibration" button .
4 . Confirm that you want to calibrate the sensor with "√" or cancel with "X" .
5 . If "√" is chosen, you must then offset the thermostat to reflect the floor
temperature actually measured .
6 . Use the "Up Arrow" or "Down Arrow" button to set the measured floor
temperature .
7 . Confirm the value with "√" . A confirmation screen will be displayed briefly .
8 . The thermostat will automatically return to "Engineer Settings" .
< >
Contents
*⁾ RTF-TC Thermostats only