Sensor Type - STIEBEL ELTRON RFT-TC Benutzerhandbuch

Sensor Type*

Mon 11:15
23.5
°
17:00
Manual Other...
Mon 11:15 Thermostat will use a
1
custom sensor type. Set
the 4 resistance values
23.5
°
for it ?
17:00
7
5
Manual Other...
Heating Schedule Heating Schedule
Adaptive Function
Heating Schedule Energy Use Energy Use Custom Sensor
6
Value 1
Open Window
User Settings Energy Use
User Settings 8
You have now set up
15° 2303 Ω
2 your custom sensor
Sensor Application
Engineer Settings Engineer Settings User Settings
7 7
Adaptive Function Sensor Type
Engineer Settings
Floor Sens. Calibr. Open Window
Custom Sensor
Room Sens. Calibr. Sensor Application Adaptive Function
Value 2
3
Open Window Temp. Scale Sensor Type
8
20° 2303 Ω
Floor Sens. Calibr. Sensor Application Factory Reset
7 7
Room Sens. Calibr. Sensor Type
Factory
Temp. Scale Floor Sens. Calibr.
Custom Sensor
Sensor - 10 kΩ Factory Factory
Room Sens. Calibr. Factory Reset
Value 3
4
Sensor - 12 kΩ Sensor - 10 kΩ Sensor - 10 kΩ
8
Temp. Scale
25°
2303 Ω
Sensor - 12 kΩ Sensor - 12 kΩ User Settings
Factory Reset
7 7
User Settings User Settings
PAGE 48
© 2018 OJ Electronics A/S
This option allows you to choose the type of floor sensor used with the thermostat .
You can therefore choose to use an existing sensor with the thermostat, e .g . in
1
renovation projects .
Choose the sensor actually used from the list . The sensor supplied with the thermostat
is an OJ sensor listed as: "Factory" .
• Factory
• Sensor 10 kΩ
• Sensor 12 kΩ
• Custom
1 . Tap the "Menu" button on the home screen .
Custom Sensor
Value 4
2 . Then tap the "Engineer Settings" button .
8
30°
2303 Ω
3 . Scroll down and tap the "Sensor Type" button .
7
4 . Tap the type of floor sensor actually used .
5 . Confirm your choice with "√" or discard it with "X" .
6 . If "Custom" is chosen, you must provide resistance values for the sensor
concerned at four given temperatures: 15°C, 20°C, 25°C and 30°C – ask the
supplier of your sensor for these values .
7 . Use the "Right Arrow" or "Left Arrow" button to toggle through the temperatures .
8 . Tap the resistance value to change it .
9 . Tap the "Up Arrow" or "Down Arrow" button to set the resistance .
10 . Then repeat steps 7-9 until all four resistance values have been set .
11 . Tap the "Left Arrow" button to return to "Engineer Settings" .
< >
Contents
*⁾ RTF-TC Thermostats only