authorized to perform installation services. Adaptations of the pasta maker to another type of
gas must be carried out by an authorized fitter.
LPG pasta boiler should be connected to a hose (hose for propane-butane with safety mark „B") via
seamless steel tubing with a length of at least 50cm. The cable should be secured with clamps at both ends
against slipping. The length of the hose cannot be less than 1.2 m and cannot exceed 3.0 m. The propane-
butane (B/P) gas cylinder must be equipped with a gas pressure reducer up to 3.7kPa
Pasta makers running on natural gas (E) should be connected to the gas network inside the building rigidly
or by means of flexible metal hoses with an updated safety mark. Use a pipe union and a 1/2" seamless pipe;
the pasta maker has a threaded connection R 1/2".
During the first installation of the device and after each change of supply (another type of gas), the supply
pressure must be verified with a manometer. The spigot for pressure checks is on the supply pipe before
the valve.
4.
TECHNICAL DATA
The gas pasta maker meets the requirements of PN-EN 203-1+A1:2014; PN-EN 203-3; PN-EN203-2-11
The appliance is designed for supply with the following gas fuels (Poland):
- 26 -