Installation - Peiying PY8307 Bedienungsanleitung

Fig.2
1. Dashboard
2. Nut (5 mm)
3. Spring washer
4. Screw (5x25 rnm)
5. Screw
6. Strap
Be sure to use the strap to secure the back of
the unit in place. The strap can be bent by hand
to the desired angle.
7. Plain washer
MOUNTING (Method B)
Installation using the screw holes on the sides of the unit.
1. Select a position where the screw holes of the bracket and
the screw holes of the main unit become aligned (are fitted),
and tighten the screws at 2 places on each side. Use either
truss screws (5x5 mm) or flush surface screws (4x5 mm).
2. Screw
3. Dashboard or Console
NOTE: The mounting box, outer trim ring, and halfsleeve are
not used for method B installation.
INPUT THE SD CARD
The SD oblique angle keeps rightward exposure, put into
the SD slot and press it again to eject.
Owner's manual
Fig.3
1. Frame
2. Insert fingers into the groove in the front
of frame and pull out to remove the frame
(when reattaching the frame, point the side
with a groove downwards and attach it).
3. Lever
Insert the levers supplied with the unit into
the grooves at both sides of the unit and
shown in figure until they click. Pulling the
levers makes possible to remove the unit
from the dashboard.
EN
15