Troubleshooting - Fakir EYE Bedienungsanleitung

EN

Troubleshooting

Fault Possible cause
Iron emits an Iron gives off an odor when
odor or smoke turned on for the first time.
Iron does not The temperature dial did not set
heat at the desired temperature.
Iron does not The water tank many be empty.
steam
Burst of steam The water tank can be empty
feature does and temperature button set to
not work shouldn't steam.
Spry mist The water tank must be at least
feature does 1/4 full.
not work
Iron is leaking Temperature should be set to
low level.
AFTER USE
Solution
Oils used during manufacture need to
be burnt off allow ten minutes for odor
to disappear.
The iron should be plugged into a 230
Volt , AC electrical outlet only. The
temperature dial must be set at the
desired temperature.
Turn the steam valve to " " and add
water. Allow the iron to heat, and then
set the steam dial to the steam setting.
The water tank must be at least 1/4 full.
Temperature must be set to steam
position. Iron should be in the
horizontal position. Prime pump briefly.
Allow a short pause between shots. Be
sure to fully depress the burst of steam
button.
Fill the iron as described in the section
"how to fill the water tank".
The variable steam dial must be set on"
",until the iron is hot. The temperature
setting is too low to produce steam.
Shot of steam used too much, allow
iron to re-heat.
20