Espa SPEEDRIVE V2 Betriebsanleitung Seite 17

CONFIGURATION CONFIGURATION
CONFIGURATION CONFIGURATION
ADDITIONAL ADDITIONAL PARAMETERS SETTING ADDITIONAL ADDITIONAL PARAMETERS SETTING PARAMETERS SETTING PARAMETERS SETTING
DISPLAY OF PARAMETERS DISPLAY OF PARAMETERS
DISPLAY OF PARAMETERS DISPLAY OF PARAMETERS
The Speedrive displays the configuration values of all its parameters.
It does not allow you to change parameters, just display them.
On the main screen press ◄ (Vis)
From any screen, tap OK to return to the main screen 2.1 From any screen, tap OK to return to the main screen 2.1
From any screen, tap OK to return to the main screen 2.1 From any screen, tap OK to return to the main screen 2.1
Screen descriptions:
Top: parameter being configured.
-
Lower left: current value of the parameter.
-
Lower right, "flashing": new value being configured.
-
Press◄ or ►, to adjust values.
-
Press OK OK OK OK to confirm.
LANGUAGE LANGUAGE LANGUAGE LANGUAGE
Select the desired language.
PRESSURE PRESSURE PRESSURE PRESSURE SET POINT SET POINT SET POINT SET POINT
Configuration of the work pressure of the unit.
CALCULATED STOP FREQUENCY CALCULATED STOP FREQUENCY
CALCULATED STOP FREQUENCY CALCULATED STOP FREQUENCY
The stop frequency is calculated automatically.
Will be recalculated every time that is changed the nominal pressure.
To set a value in the manual mode, press◄ (Man)
STOP FREQUENCY MANUALLY STOP FREQUENCY MANUALLY STOP FREQUENCY MANUALLY STOP FREQUENCY MANUALLY
Enter the desired stop frequency.
Note: This value should only be Note: This value should only be recorded
Note: This value should only be Note: This value should only be
FINE ADJUSTMENTS FINE ADJUSTMENTS
FINE ADJUSTMENTS FINE ADJUSTMENTS
To set additional parameters, press ▼(Config)
Note: This values should only be recorded by experts. Note: This values should only be recorded by experts. Note: This values should only be recorded by experts. Note: This values should only be recorded by experts.
To complete the setup, press ◄ (Exit)
DISPLAY OF PARAMETERS DISPLAY OF PARAMETERS DISPLAY OF PARAMETERS DISPLAY OF PARAMETERS
Press OK OK to confirm. OK OK
Parameters can only be displayed, not modified.
To display the alarms, press ◄ (Alarm)
To return to the main screen, press ► (Auto)
- 17 -
recorded by experts. by experts.
recorded recorded by experts. by experts.