Sony PDBK-202 Bedienungsanleitung Seite 9

Additional Setup Menu
Items
When this board is installed in the PDW-HR1, the menu
items shown in the following table appear in the setup
menu.
In the "Settings" column of the table, the factory default
setting is underlined.
Refer to Chapter 8 "Menus" in the PDW-HR1 Operation
Manual for more information about setup menu
operations.
Item Item name
number
831 TS OUT AUDIO
MODE
926 DVB-ASI
SETTING
Sub-item
1 TS i.LINK
MODE
2 ENC RATE
(Mbps)
Settings
Select the number of output
channels for i.LINK TS (HDV)
signals.
2ch: 2 channels
4ch: 4 channels
Selects the DVB-ASI output.
Selects the TS i.LINK mode.
HDV: HDV mode
When this mode is selected,
the "Manual" setting is
disabled.
Manual: Encoding rate mode
When the video format is
720P
• This item does not appear.
• No signals are output from
the (i.LINK) HDV TS
connector.
Sets the encoding rate.
25.00: Sets the encoding
rate.
---: When sub item TS i.LINK
MODE of menu item 926
is set to "HDV".
You can set this in units of
0.01 Mbps (or 0.20 Mbps
when the SHIFT button is
held down) over the range
from 15.00 Mbps to 43.25
Mbps.
Item Item name
number
926 3 RESOLUTION Selects the number of
4 PROGRAM
NUMBER
5 OUTPUT
MODE
6 PACKET
LENGTH
7 META
PACKET OUT
8 PID(PMT)
Settings
horizontal pixels for the 1080i
format.
1440: 1440
When sub item TS i.LINK
MODE of menu item 926 is
set to "HDV", this is fixed as
"1440".
1920: 1920
The 1920 setting is enabled
when the encoding rate is
35.00 Mbps or higher.
Note
This item does not appear
when the video format is
720P.
Sets the program number.
00100: Sets the program
number (1 to 65535
(FFFFh)).
---: When sub item TS i.LINK
MODE of menu item 926
is set to "HDV".
You can set this in units of 1
(or 200 when the SHIFT
button is held down).
Selects the output mode.
Packt: Packet mode
Burst: Burst mode
Selects the packet length.
188 Byte: 188 bytes
204 Byte: 204 bytes
Specifies output of DVB-ASI
signal meta packets.
off: Do not output meta
packets.
on: Output meta packets.
---: When sub item TS i.LINK
MODE of menu item 926
is set to "HDV".
Changes the PMT packet PID
value for DVB-ASI output.
0081h: Set PID value.
---: When sub item TS i.LINK
MODE of menu item 926
is set to "HDV".
You can set the value over the
range from 0030h to 1FFEh
in 1h units (or 20h units,
when the SHIFT button is
held down).
Note
Do not set to the same PID
value as other values.
Additional Setup Menu Items
9