System Configuration Examples - Sony PDBK-202 Bedienungsanleitung

Overview
The PDBK-202 MPEG TS Board (called "this board" in
the following) is an option board for installation in the
Sony PDW-HR1 Professional Disc Recorder.
The principal features of this board are as follows.
When this board is installed in the PDW-HR1, you can
1)
input MPEG TS signals (IEEE 1394 compliant, interlace
or progressive scan, compatible with the HDV
format), and record these signals on XDCAM HD discs.
You can also play back XDCAM HD discs and output
MPEG TS signals (IEEE 1394 compliant, interlace or
progressive scan, compatible with the HDV 1080i format)
and DVB-ASI TS signals.
1) MPEG TS: MPEG-2 transport streams containing MPEG video, MPEG
audio, and control information. This is the standard interface for HDV
equipment.
2) HDV and are trademarks of Sony Corporation and Victor
Company of Japan, Limited.
3) HDV 1080i: Refers to devices compliant with the "HDV 1080i Standard"
for recording HD signals on DV tape. Supports HDV 1080/59.94i or 1080/
29.97P and HDV 1080/50i or 1080/25P.
About operating instructions
Refer to the PDW-HR1 Operation Manual (in English).
PDW-HR1: 1st Edition
The following is supplementary information to be added to
the above manual when this board has been installed in the
PDW-HR1.
Notes
• This board cannot record DV signals.
• i.LINK (TS) is not output when the video format is 720P.
• If, after editing material with a nonlinear editor
connected to the PDW-HR1, you then want to write the
material back to a PDW-HR1 disc, set F2: PB/EE on the
HOME page of the function menu to "EE".
The firmware of the PDW-HR1 may need to be upgraded
when you install this board. For details, contact your Sony
dealer or a Sony service representative.
System Configuration
Examples
The following figures show examples of systems
configured with this board installed in the PDW-HR1.
Examples of i.LINK TS input/output usage
2) 3)
1080i
a) i.LINK TS
Note
Before connecting an HDV camcorder or an HDV recorder
by an i.LINK cable, set up the camcorder or recorder to
input/output HDV signals via the i.LINK interface.
For details about i.LINK interface settings, refer to the
Operating Instructions for the HDV camcorder or HDV
recorder.
PDW-HR1 (with this board
installed)
a)
HDV camcorder
HDV compatible
a)
nonlinear editing
system
a) a)
HDV recorder
Overview/System Configuration Examples
GB
7