Specifications; Accessories Supplied - Sony PDBK-202 Bedienungsanleitung

Notes about i.LINK
connections
• Check that connectors are oriented properly before
connecting an i.LINK cable to your computer or to the
PDW-HR1. Trying to force an improperly oriented
connector may damage the connector or the PDW-HR1.
• Connect the i.LINK cable to your computer before
connecting it to the PDW-HR1. The PDW-HR1 may be
damaged by static electricity if you connect the cable to
the PDW-HR1 first.
• Before connecting or disconnecting an i.LINK cable
between the PDW-HR1 and other equipment with an
i.LINK connector, always power both the PDW-HR1
and the connected equipment off and disconnect all
power plugs from their power outlets.
Inserting or removing an i.LINK connector with the
power plugs still connected may cause a damaging surge
of high-voltage power to flow from the equipment's
i.LINK connector into the PDW-HR1.
• A damaging surge of high-voltage power can still flow
into the PDW-HR1 from the i.LINK connector of
connected equipment even when a separate i.LINK cable
is connected to another i.LINK connector on the
equipment, for example when connecting a hard disk to
a computer with an i.LINK interface card that provided
multiple connectors.
Always power all equipment off and disconnect all
power plugs from their power outlets, both on the PDW-
HR1 and on the connected computer and its peripherals,
before connecting an i.LINK cable.
• Before turn on or off the power switch of the PDW-HR1,
always stop operation of all devices connected to the
PDW-HR1 over the i.LINK interface.
• If MPEG TS signal transmission is not possible with the
PDW-HR1 powered on, turn off the power switch of the
PDW-HR1 and then turn it on again.

Specifications

General
Power requirements and current consumption
+5.8 V, 0.1 A
+3.3 V, 0.7 A
+2.5 V, 0.5 A
(Power is supplied from PDW-HR1.)
Dimensions (w/h)
102×86 mm (4
Mass Approx. 54 g (1.9 oz)

Accessories supplied

Fitting screw (4)
Operation and Installation Guide (1)
Installation Manual (1)
Design and specifications are subject to change without
notice.
Note
Always verify that the unit is operating properly before
use. SONY WILL NOT BE LIABLE FOR DAMAGES
OF ANY KIND INCLUDING, BUT NOT LIMITED
TO, COMPENSATION OR REIMBURSEMENT ON
ACCOUNT OF THE LOSS OF PRESENT OR
PROSPECTIVE PROFITS DUE TO FAILURE OF
THIS UNIT, EITHER DURING THE WARRANTY
PERIOD OR AFTER EXPIRATION OF THE
WARRANTY, OR FOR ANY OTHER REASON
WHATSOEVER.
Notes about i.LINK connections/Specifications
1 1
/ ×3 / inches)
8 2
11